TUR
SpeedyBee F405 AIO 40A Bluejay 25.5x25.5 3-6S Flight Controller
- Power Input: 3S-6S LiPo battery
- Mounting: 25.5 x 25.5 mm, 2 mm hole diameter
- Dimensions: 33.0 mm (length) x 33.0 mm (width) x 8 mm (height)
- Weight: 13.6 g (including CNC)
- Continuous Current: 40A
- Burst Current: 45A (10s)
Details
SpeedyBee F405 AIO 40A Bluejay 25.5x25.5 3-6S Flight Controller
Box Contents
- Available in the image
1. Open Aio Manual in a New Tab
Click here to open the Aio Manual in a new tab2. Download Aio Manual
Click here to download the Aio ManualAio: SpeedyBee F405 AIO 40A Bluejay 25.5x25.5 3-6S Flight Controller Manual Connection Image
Open the Manual in a New Tab
Power Input (FC):
3S-6S LiPo battery
Mounting (FC):
25.5 x 25.5 mm, 2 mm hole diameter
Dimension (FC):
33.0 mm (length) x 33.0 mm (width) x 8 mm (height)
Weight (FC):
13.6 g (including CNC)
MCU (FC):
STM32F405
IMU(Gyro) (FC):
ICM-42688P
USB Connection (FC):
Type-C
Barometer (FC):
SPA06-003
OSD (FC):
Supported
BLE Bluetooth (FC):
Supported, Bluetooth speed upgrade - 2.0
Flash FC Firmware Wirelessly (FC):
Supported (no need to press the physical BOOT button)
Download/Analyze Blackbox (FC) :
Not supported
DJI Air Unit 6-pin Connector (FC):
Supported, can connect directly to DJI O3/RunCam Link/Caddx Vista without changing the wire sequence
Supports both 6-pin direct placement and soldering
Flash(for BlackBox) (FC):
8MB
Current Sensor (FC):
Not specified
BetaFlight Camera Control Pad (FC):
Supported
5V Output (FC):
Three 5V outputs; total current 2A; shared with 4V5
4V5 Output: Two 4V5 outputs; total current 1A
9V Output (FC):
None (comes with an external BEC module, can switch between 5V and 9V); total current output 2A
ESC Signal Pads (FC):
M1 - M4
UART (FC):
4 fully functional serial ports (UART3, UART4, UART5, UART6 + SBUS[R2])
ESC Telemetry UART (FC):
None
LED Pad (FC):
Supported, used to control WS2812 LED lights
Buzzer (FC):
BZ+ and BZ- pads used for 5V Buzzer
BOOT Button (FC):
Supported, to enter DFU mode for firmware recovery, hold down the BOOT button while powering on
Supported Flight Controller (FC):
BetaFlight (Default), INAV
Firmware Target Name (FC):
SPEEDYBEE F405AIO
Power Input (ESC):
3-6S LiPo battery
Continuous Current (ESC):
40A
Burst Current (ESC):
45A (10s)
ESC Protocol (ESC):
Supports DSHOT600/300; other protocols may cause serious errors, please use with caution.
Power Output (ESC):
VBAT battery voltage (used to power the flight controller)
Current Sensor (ESC):
Supported (Scale = 254, Offset = 0)
Firmware (ESC):
