Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

HGLRC SPECTER 40A 4-6S MPU6000 AIO

Brand
Category: AIO
Kod: MS46891340
(Review Pending)
  • Power Input: 4-6S LiPo (14.8-22.2V)
  • Mounting: 25.5x25.5mm (M2)
  • Dimensions: 34x34mm
  • Weight: 9.81g
  • Continuous Current: 40A x4
  • Burst Current: 50A x4 (10 seconds)

Details

The HGLRC SPECTER 40A is a 4-6S AIO flight controller with an STM32F722 processor and MPU6000 gyro. It has direct plug-in connectors for the camera, receiver and HD/analog two-in-one video transmission system, and supports GPS/compass. It features OSD support, a 16MB black box, 5 UARTs, a flight controller status indicator, LED and buzzer support and a 5V 2A BEC. The board has a high-density waterproof coating. The ESC section is 8-bit and comes with BLHeli_S firmware by default; Bluejay/Bluebird can be flashed if desired (PWM 24-48kHz, 96kHz with Bluebird). It delivers 40A x4 continuous and 50A x4 (10 s) burst current and supports DShot300/600, Oneshot and MultiShot. According to HGLRC it is suitable for 2-4 inch cinewhoop and toothpick frames. Weight is 9.81g. Package contents: AIO, XT60 16AWG 100mm power cable, 35V 220µF solid capacitor, camera cable (SH1.0-3P/SH1.25-3P), receiver cable (SH1.0-4P), HD video transmission cable (SH1.0-7P/SH1.0-6P), analog video transmission cable (GH1.25-6P/SH1.0-7P), 4x M2x6.6 shock absorbers, 4x M2x12 screws and 4x M2 lock nuts.

Box Contents

1. Open Aio Manual in a New Tab
Click here to open the Aio Manual in a new tab
2. Download Aio Manual
Click here to download the Aio Manual
Aio: HGLRC SPECTER 40A 4-6S MPU6000 AIO Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    Power Input (FC):
    4-6S LiPo (14.8-22.2V; 2-6S on the spec sheet image)
    Mounting (FC):
    25.5x25.5mm, M2
    Dimension (FC):
    34x34mm
    Weight (FC):
    9.81g
    MCU (FC):
    STM32F722
    IMU(Gyro) (FC):
    MPU6000
    USB Connection (FC):
    Not specified
    Barometer (FC):
    Not specified
    OSD (FC):
    Supported
    BLE Bluetooth (FC):
    Not specified
    Flash FC Firmware Wirelessly (FC):
    Not specified
    Download/Analyze Blackbox (FC) :
    Yes (16MB black box)
    DJI Air Unit 6-pin Connector (FC):
    Yes (HD/analog two-in-one direct plug-in connector, HD cable included)
    Flash(for BlackBox) (FC):
    16MB
    Current Sensor (FC):
    Not specified
    BetaFlight Camera Control Pad (FC):
    Not specified
    5V Output (FC):
    5V 2A
    9V Output (FC):
    None
    ESC Signal Pads (FC):
    Not specified
    UART (FC):
    5 UARTs
    ESC Telemetry UART (FC):
    Not specified
    LED Pad (FC):
    Yes
    Buzzer (FC):
    Yes
    BOOT Button (FC):
    Not specified
    Supported Flight Controller (FC):
    Betaflight (HGLRCF722AIO target)
    Firmware Target Name (FC):
    HGLRCF722AIO
    Power Input (ESC):
    4-6S LiPo (14.8-22.2V; 2-6S on the spec sheet image)
    Continuous Current (ESC):
    40A x4
    Burst Current (ESC):
    50A x4 (10 seconds)
    ESC Protocol (ESC):
    DShot300/600, Oneshot, MultiShot
    Power Output (ESC):
    Not specified
    Current Sensor (ESC):
    Not specified
    Firmware (ESC):
    ESC: BLHeli_S 8-bit (Bluejay/Bluebird flashable, PWM 24-48kHz, Bluebird 96kHz) / FC: HGLRCF722AIO