Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC TAKER F411 8Bit 12A AIO

Brand
Category: AIO
Kod: MS46891340
(Review Pending)
  • Power Input: 2-4S LiPo
  • Mounting: 25.5x25.5mm (M2)
  • Dimensions: 31.2x31.2mm
  • Weight: 7g
  • Continuous Current: 12A
  • Burst Current: 13A

Details

The GEPRC TAKER F411 8Bit 12A AIO is an AIO board that combines the flight controller and a 4in1 ESC on one board. Flight controller: STM32F411 processor, ICM42688-P gyro, 16Mb Blackbox, OSD: Betaflight OSD (AT7456E), USB: Micro USB, UART: R1 T1 / R2 T2 (ters port: NR2), buzzer, LED, firmware target GEPRC_F411_SX1280. ESC: input 2-4S LiPo, 12A continuous, 13A burst, DShot300, Oneshot, Multishot, Bluejay 0.16, 48kHz (G-H-30). Board size 31.2x31.2mm, mounting 25.5x25.5mm (M2), weight 7g. It comes in two versions, with a built-in SPI ELRS 2.4G receiver or without a receiver. The gyro runs at an 8K sampling rate.

Box Contents

  • 1 x TAKER F411 12A AIO (with or without ELRS receiver), 1 x XT30 5.5cm 20AWG power cable, 8 x M2x6.5mm damping balls (4 red, 4 black), 1 x 35V 220uF capacitor, 5 x M1.4x5 self-tapping screws, 1 x instruction manual, 1 x aluminium foil bag
1. Open Aio Manual in a New Tab
Click here to open the Aio Manual in a new tab
2. Download Aio Manual
Click here to download the Aio Manual
Aio: GEPRC TAKER F411 8Bit 12A AIO Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    Power Input (FC):
    2-4S LiPo
    Mounting (FC):
    25.5x25.5mm (M2)
    Dimension (FC):
    31.2x31.2mm
    Weight (FC):
    7g
    MCU (FC):
    STM32F411
    IMU(Gyro) (FC):
    ICM42688-P
    USB Connection (FC):
    Micro USB
    Barometer (FC):
    Not specified by manufacturer
    OSD (FC):
    Betaflight OSD (AT7456E)
    BLE Bluetooth (FC):
    Not specified by manufacturer
    Flash FC Firmware Wirelessly (FC):
    Not specified by manufacturer
    Download/Analyze Blackbox (FC) :
    Not specified by manufacturer
    DJI Air Unit 6-pin Connector (FC):
    Not specified by manufacturer
    Flash(for BlackBox) (FC):
    16Mb
    Current Sensor (FC):
    Yes (current meter scale 210)
    BetaFlight Camera Control Pad (FC):
    Not specified by manufacturer
    5V Output (FC):
    Not specified by manufacturer
    9V Output (FC):
    Not specified by manufacturer
    ESC Signal Pads (FC):
    Not specified by manufacturer
    UART (FC):
    R1 T1 / R2 T2 (ters port: NR2)
    ESC Telemetry UART (FC):
    Not specified by manufacturer
    LED Pad (FC):
    Yes
    Buzzer (FC):
    Yes
    BOOT Button (FC):
    Not specified by manufacturer
    Supported Flight Controller (FC):
    Betaflight
    Firmware Target Name (FC):
    GEPRC_F411_SX1280
    Power Input (ESC):
    2-4S LiPo
    Continuous Current (ESC):
    12A
    Burst Current (ESC):
    13A
    ESC Protocol (ESC):
    DShot300, Oneshot, Multishot
    Power Output (ESC):
    Not specified by manufacturer
    Current Sensor (ESC):
    Yes (current meter scale 210)
    Firmware (ESC):
    Bluejay 0.16, 48kHz (G-H-30)