TUR
FETtec AIO 35A
- Power Input: 3S - 6S LiPo (12-25V)
- Mounting: 20 x 20 mm (M2, expandable to M3)
- Dimensions: 30 x 37.5 mm
- Weight: 8.9 g
- Continuous Current: 35A x4
- Burst Current: Not Specified
Details
The FETtec AIO 35A is an AIO that combines an STM32G4 (170MHz + math accelerator) FC processor, MPU6000 gyro, and a 4-channel STM32G071 (64MHz) based 35A ESC with active current limiting on a single board. It comes with KISS FC firmware from the factory and can also be flashed with FETtec Alpha FC firmware (KISS firmware version 1.3RC47i or newer is required). There are 2 dedicated 5V BECs: a fixed 5V for the RX and a switchable 5V/16V for the VTX (with true Pit-Mode support), each providing up to 600mA. A 1x 8-pin connector is used for analog or digital VTX/camera connections, including DJI/Caddx/Runcam Vista, Fatshark Shark Byte, Caddx Walksnail, and DJI O3 Air Unit. Two 4-pin connectors are used for the receiver and additional serial connections. The integrated graphical OSD provides full KISS Tuning support with both KISS and FETtec Alpha firmware and can be disabled for digital systems. An I2C OLED display connection (128x64px, recommended 1.3" SSH1106) enables configuration without a computer; this connection blocks Serial3 (shared with digital OSD/analog VTX control). Flight log files can be obtained using OpenLager/OpenLog (separate accessory). The package includes a 50V 470µF capacitor, 2x 4-pin cables, 1x 8-pin cable, and standoffs. Note: The product is currently shown as out of stock on the manufacturer’s own website.
