TUR
GEP-TAKER G4 35A AIO
- Power Input: 2S-4S LiPo battery
- Mounting: 25.5-26.5 Φ3.05mm
- Dimensions: 33.4×34.4mm
- Weight: 7.7g
- Continuous Current: 35A
- Burst Current: 45A(5″)
Details
TAKER G4 35A, a newly developed AIO flight controller by the GEPRC team. It adopts the G473 main controller and has more redundant computing power.
In response to market demand, the TYPE-C interface has been upgraded, and the power supply pads and motor pads have been optimized for easier soldering. It is compatible with frames that have two mounting holes of 25.5-26.5 mm and may be compatible with more frames.
We are committed to producing smaller, lighter, and higher-performance flight controllers.
Box Contents
- Image Available
Power Input (FC):
2S-4S LiPo battery
Mounting (FC):
25.5-26.5 Φ3.05mm
Dimension (FC):
33.4×34.4mm
Weight (FC):
7.7g
MCU (FC):
STM32G473CEU6
IMU(Gyro) (FC):
ICM 42688-P
USB Connection (FC):
Type-C
Barometer (FC):
Not Supported
OSD (FC):
Betaflight OSD with AT7456Ev
BLE Bluetooth (FC):
Not Supported
Flash FC Firmware Wirelessly (FC):
Supports Type-C
Download/Analyze Blackbox (FC) :
Not Supported
DJI Air Unit 6-pin Connector (FC):
Supported, can connect to DJI O3 AIR Unit/DJI AIR Unit/DJI Vista
Flash(for BlackBox) (FC):
Not Specified
Current Sensor (FC):
Supported
BetaFlight Camera Control Pad (FC):
Not Specified
5V Output (FC):
5 outputs of 5V
9V Output (FC):
7.4-26.4v NOTE: For digital system
ESC Signal Pads (FC):
M1 - M4
UART (FC):
R1 T1 / R2 T2 / R4 T4 / R5 T5
ESC Telemetry UART (FC):
Not Specified
LED Pad (FC):
Supported
Buzzer (FC):
5V Buzzer used for BZ+ and BZ- pad
BOOT Button (FC):
Supported, enter DFU mode to recover firmware by holding down the BOOT button while powering on
Supported Flight Controller (FC):
BetaFlight
Firmware Target Name (FC):
TAKERG4AIO
Power Input (ESC):
2-4S LiPo battery
Continuous Current (ESC):
35A
Burst Current (ESC):
45A(5″)
ESC Protocol (ESC):
Dshot600, Oneshot, Multishot
Power Output (ESC):
Not Specified
Current Sensor (ESC):
Supported
Firmware (ESC):
