Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

HGLRC SPECTER 25A F722 AIO

Brand
Category: AIO
Kod: MS46891340
(Review Pending)
  • Power Input: 3-6S LiPo (11.1-22.8V)
  • Mounting: 25.5x25.5mm (M2)
  • Dimensions: 34x34x6.7mm
  • Weight: 12.05g
  • Continuous Current: 25A x4
  • Burst Current: 30A x4 (under 10 seconds)

Details

The HGLRC SPECTER 25A is a 3-6S AIO flight controller with an STM32F722 (216MHz) processor and built-in Betaflight Bluetooth tuning. By connecting to the SpeedyBee app, the serial ports, PID and other flight controller parameters can be adjusted anytime, anywhere. It features an MPU6000 gyro (with reserved pads for ICM42688), AT7456E OSD, DPS310 barometer and 16MB black box, with 5 UARTs and a 5V 2A BEC. It has a direct plug-in connector for DJI systems, a two-in-one socket supporting digital and analog VTX, receiver and camera sockets, GPS/compass support, a flight controller status indicator and LED/buzzer support. The ESC section uses a BLHeli_S 8-bit chip and comes with Bluejay (Q-H-30) firmware, delivering 25A x4 continuous and 30A x4 (under 10 s) burst current. PWM 24-48kHz (96kHz with Bluebird). Supports DShot300/600. Note: 'HD/Analog VTX' in the product name refers to VTX connection support; the board has no built-in VTX. Package contents: AIO, 14AWG 100mm XT60 power cable, 18AWG 70mm XT30 power cable, SH1.0-6P DJI cable, 1.25-3P camera cable and accessory kit (capacitor, shock absorbers, wires).

Box Contents

1. Open Aio Manual in a New Tab
Click here to open the Aio Manual in a new tab
2. Download Aio Manual
Click here to download the Aio Manual
Aio: HGLRC SPECTER 25A F722 AIO Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    Power Input (FC):
    3-6S LiPo (11.1-22.8V)
    Mounting (FC):
    25.5x25.5mm, M2
    Dimension (FC):
    34x34x6.7mm
    Weight (FC):
    12.05g
    MCU (FC):
    STM32F722 (216MHz)
    IMU(Gyro) (FC):
    MPU6000 (ICM42688 pedleri ayrılmış)
    USB Connection (FC):
    Type-C
    Barometer (FC):
    DPS310
    OSD (FC):
    Supported (AT7456E)
    BLE Bluetooth (FC):
    Yes (Betaflight Bluetooth, SpeedyBee APP)
    Flash FC Firmware Wirelessly (FC):
    Not specified
    Download/Analyze Blackbox (FC) :
    Yes (16MB black box)
    DJI Air Unit 6-pin Connector (FC):
    Yes (DJI direct plug-in, SH1.0-6P cable included)
    Flash(for BlackBox) (FC):
    16MB
    Current Sensor (FC):
    Not specified
    BetaFlight Camera Control Pad (FC):
    Not specified
    5V Output (FC):
    5V 2A
    9V Output (FC):
    None
    ESC Signal Pads (FC):
    Not specified
    UART (FC):
    5 UARTs
    ESC Telemetry UART (FC):
    Not specified
    LED Pad (FC):
    Yes
    Buzzer (FC):
    Yes
    BOOT Button (FC):
    Not specified
    Supported Flight Controller (FC):
    Betaflight (HGLRCF722AIOV2 target)
    Firmware Target Name (FC):
    HGLRCF722AIOV2
    Power Input (ESC):
    3-6S LiPo (11.1-22.8V)
    Continuous Current (ESC):
    25A x4
    Burst Current (ESC):
    30A x4 (under 10 seconds)
    ESC Protocol (ESC):
    DShot300/600
    Power Output (ESC):
    Not specified
    Current Sensor (ESC):
    Not specified
    Firmware (ESC):
    ESC: Q-H-30 (Bluejay, BLHeli_S 8-bit), PWM 24-48kHz (Bluebird 96kHz) / FC: HGLRCF722AIOV2