TUR
NewBeeDrone X FETtec Infinity AIO G4
- Power Input: 3S - 6S LiPo
- Mounting: 30.5 x 30.5 mm
- Dimensions: 41 x 37 x 7.6 mm
- Weight: 19.4g (with grommets) / 18.8g (without grommets)
- Continuous Current: 45A x4
- Burst Current: 55A x4
Details
The NewBeeDrone X FETtec Infinity AIO G4 is a 30.5x30.5 AIO developed jointly by NewBeeDrone and FETtec. It features a dustproof and moisture-resistant dual CNC aluminum heatsink housing. The flight controller uses an STM32G474 processor with FETtec Alpha Firmware 0.7-62 and an MPU6000 gyro. On the ESC side, four STM32G071 chips running at 64MHz provide 45A continuous current and 55A burst current per channel. A 6-pin DJI FPV Air Unit connector and a dedicated 12V 2A BEC are included for the Air Unit. There is also a 5V 3A power output for external LED or GPS modules. For analog builds, the integrated FETtec OSD support can be enabled through Serial3 (Settings > FC Setup > Serial > MSP Port1 - Serial3). With the OneWire BUS, all motor signals and telemetry can be transmitted through a single wire, supporting looptimes of up to 8kHz. The box includes a DJI O3 cable, 2x 16-pin cables, locking nuts, M3x14 screws, grommets, a 470uF 35V capacitor, and an XT60 cable. Note: No downloadable manual PDF could be found for this product on FETtec's official website or in the other sources reviewed. The information has been compiled from the official FETtec product page description. The product is currently out of stock on the FETtec website.
