Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC SPAN F722 HD STACK

Brand
Category: Stack
Kod: MS46891340
(Review Pending)
  • Power Input: 3-6S LiPo
  • Continuous Current (ESC): 50A
  • Mounting (ESC): Not specified by manufacturer
  • MCU: STM32F722RET6
  • BEC: 5V + 9V
  • Burst Current (ESC): 55A (5 s)

Detail

The GEPRC SPAN F722 HD STACK is a stack made of the GEP-F722-HD flight controller with an STM32F722RET6 processor and the GEP-G50A BL32 50A 4in1 ESC. Flight controller: MPU6000 (SPI), 16Mb Blackbox, Type-C USB, OSD: AT7456E, dual BEC (5V + 9V), 5 UARTs, input 3-6S LiPo, size 36x36mm, mounting φ4mm hole, φ3mm with grommets (hole spacing not specified), firmware target GEPRCF722, supported firmware Betaflight. ESC: MCU STM32F051K86, input 3-6S LiPo, ammeter, telemetry, 50A continuous, 55A (5 s) burst, DShot1200/DShot600, PWM, Multishot, OneShot, mounting Not specified by manufacturer, ESC target/firmware GEPRC-BL32-4IN1 (BLHeli_32). The manufacturer lists the BEC outputs as 5V and 9V without current ratings. BLHeliSuite32 is used for ESC configuration. Note: on this page the manufacturer writes the ESC MCU as "STM32FO51K86"; the F405 version's page lists STM32F051K86. Supported receiver protocols: SBUS, PPM, CRSF, DSMX, iBus.

Box contents

  • 1 x GEP-F722-HD flight controller, 1 x GEPRC G50A ESC, 1 x 35V 470uF capacitor, 4 x M4-to-M3 silicone grommets, 4 x M3*22mm screws, 4 x M3*30mm screws, 1 x XT60 power cable, 1 x ESC cable, 1 x DJI cable
1. Open STACK Manual in a New Tab
Click here to open the STACK Manual in a new tab
2. Download STACK Manual
Click here to download the STACK Manual
STACK: GEPRC SPAN F722 HD STACK Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU (FC):
    STM32F722RET6
    IMU(Gyro)(FC):
    MPU6000 (SPI)
    USB Port Type (FC):
    Type-C
    Barometer (FC):
    Supported (BMP280)
    OSD Chip (FC):
    AT7456E
    BLE Bluetooth (FC):
    Not specified by manufacturer
    DJI Air Unit Connection Way (FC):
    Direct plug-in for the DJI Digital FPV System
    6-pin DJI Air Unit Plug (FC):
    Supported
    Flash(for BlackBox) (FC):
    16Mb
    BetaFlight Camera Control Pad (FC):
    Not specified by manufacturer
    Power Input (FC):
    3-6S LiPo
    5V Output (FC):
    5V
    9V Output (FC):
    9V
    3.3V Output (FC):
    Not specified by manufacturer
    4.5V Output (FC):
    Not specified by manufacturer
    ESC Signal Pads (FC):
    Not specified by manufacturer
    UART (FC):
    5 UARTs
    ESC Telemetry UART (FC):
    Not specified by manufacturer
    LED Pad (FC):
    Not specified by manufacturer
    Buzzer (FC):
    Not specified by manufacturer
    BOOT Button (FC):
    Not specified by manufacturer
    Supported Flight Controller Firmware (FC):
    Betaflight
    Firmware Target Name (FC):
    GEPRCF722
    Mounting (FC):
    φ4mm hole, φ3mm with grommets (hole spacing not specified)
    Dimension (FC):
    36x36mm
    Weight (FC):
    Not specified by manufacturer
    Firmware (ESC):
    FC: GEPRCF722 / ESC: GEPRC-BL32-4IN1 (BLHeli_32)
    PC Configurator Download Link (ESC):
    https://github.com/betaflight/betaflight-configurator/releases
    Continuous Current (ESC):
    50A
    Burst Current (ESC):
    55A (5 s)
    TVS Protective diode (ESC):
    Not specified by manufacturer
    External Capacitor (ESC):
    35V 470uF capacitor included
    ESC Protocol (ESC):
    DShot1200/DShot600, PWM, Multishot, OneShot
    Power Input (ESC):
    3-6S LiPo
    Power Output (ESC):
    Not specified by manufacturer
    Current Sensor (ESC):
    Supported (ammeter)
    ESC Telemetry (ESC):
    Supported
    Mounting (ESC):
    Not specified by manufacturer
    Dimension (ESC):
    Not specified by manufacturer
    Weight (ESC):
    Not specified by manufacturer