Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

SpeedyBee F7 Mini 35A 3-6S 8-bit Flight Controller Stack

Brand
Category: Stack
Kod: MS46891340
(Review Pending)
  • Power Input (FC and ESC): 3-6S LiPo
  • Continuous Current (ESC): 35A * 4
  • Mounting (FC and ESC): 20 x 20mm, 3.6mm hole diameter
  • Dimensions: (FC) 30 x 30 x 7.5mm - (ESC) 35 * 35 * 5.5mm
  • Weight: (FC) 5.7g - (ESC) 7g
  • PWM Frequency Range: X

Detail

Wireless fully-featured flight controller setup Wireless fully-featured BLHeli_S ESC setup High-performance F7 flight controller CPU Real 35A BLHeli_S DSHOT600 ESC Built-in Bluetooth 4.0 BLE chip

Box contents

  • Visually available
1. Open STACK Manual in a New Tab
Click here to open the STACK Manual in a new tab
2. Download STACK Manual
Click here to download the STACK Manual
STACK: SpeedyBee F7 Mini 35A 3-6S 8-bit Flight Controller Stack Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU (FC):
    STM32F722
    IMU(Gyro)(FC):
    BMI270 for current batches; MPU6000 for older batches before May 2022.
    USB Port Type (FC):
    Type-C
    Barometer (FC):
    N/A
    OSD Chip (FC):
    AT7456E chip
    BLE Bluetooth (FC):
    Supported. Used for flight controller configuration (MSP must be enabled on UART 6 at 115200 Baud rate)
    DJI Air Unit Connection Way (FC):
    Supported
    6-pin DJI Air Unit Plug (FC):
    Not specified
    Flash(for BlackBox) (FC):
    8MB
    BetaFlight Camera Control Pad (FC):
    Yes (CC pad)
    Power Input (FC):
    3S - 6S Lipo
    5V Output (FC):
    6 group 5V output, five +5V pads, and 1 BZ+ pad (used for Buzzer). Total current load is 2.5A.
    9V Output (FC):
    2 group 9V output, total current load 2A.
    3.3V Output (FC):
    Supported. Current load up to 500mA.
    4.5V Output (FC):
    No
    ESC Signal Pads (FC):
    M1 - M4
    UART (FC):
    Full UART * 3 (UART1, UART2, UART3)
    ESC Telemetry UART (FC):
    R4 (UART4)
    LED Pad (FC):
    Used for WS2812 LED
    Buzzer (FC):
    BZ+ and BZ- pads used for 5V Buzzer
    BOOT Button (FC):
    Used to enter DFU mode
    Supported Flight Controller Firmware (FC):
    BetaFlight (Default)
    Firmware Target Name (FC):
    For current batches SPEEDYBEEF7MINIV2 (Gyro: BMI270); for older batches before May 2022 SPEEDYBEEF7MINI (Gyro: MPU6000).
    Mounting (FC):
    20 x 20mm, 3.5mm hole diameter
    Dimension (FC):
    30 x 30 x 7.5mm
    Weight (FC):
    5.7g
    Firmware (ESC):
    BLHeli_S JH40
    PC Configurator Download Link (ESC):
    Not specified
    Continuous Current (ESC):
    35A * 4
    Burst Current (ESC):
    45A (5 seconds)
    TVS Protective diode (ESC):
    Not specified
    External Capacitor (ESC):
    Not specified
    ESC Protocol (ESC):
    DSHOT300/600
    Power Input (ESC):
    3-6S LiPo
    Power Output (ESC):
    VBAT
    Current Sensor (ESC):
    Supported (Scale=250 Offset=-500)
    ESC Telemetry (ESC):
    Not supported
    Mounting (ESC):
    20 x 20mm, 3.6mm hole diameter
    Dimension (ESC):
    35 * 35 * 5.5mm
    Weight (ESC):
    7g