GEPRC TAKER F722 BL32 E55A SE STACK

Detail

The GEPRC TAKER F722 BL32 E55A SE STACK is a stack made of the TAKER F722 SE flight controller with an STM32F722RET6 processor and the TAKER E55_96K BL32 55A 4in1 ESC. Flight controller: ICM42688-P, 32Mb Blackbox, Type-C USB, OSD: AT7456E, dual BEC (5V@2.5A + 10V@2A), 6 UARTs (UART6 for ESC only), input 2-6S LiPo (7.4-25.2V), size 31.7x31.5mm, mounting 25.5x25.5mm (φ4mm hole, converts to 3mm or 2mm screws with silicone), weight 6.0g, firmware target TAKERF722SE, supported firmware Betaflight. ESC: input 2-6S LiPo (7.4-25.2V), ammeter, telemetry, PWM 24K-96K, 55A continuous, 60A (5 s) burst, Oneshot125/Oneshot42/Multishot/DShot150/300/600, mounting 25.5x25.5mm, weight 9.6g, ESC target/firmware ST_G0_05. This racing-oriented stack uses 25.5x25.5mm mounting holes and fits most frames designed for AIO boards. The ESC uses metal-packaged MOSFETs. Note: the manufacturer's spec table lists the ESC at 55A continuous / 60A burst, while the product description gives a measured 50A continuous and 55A instantaneous.

Box contents

• 1 x flight controller, 1 x ESC, 1 x 35V 470uF capacitor, 1 x XT60 power cord, 1 x 8pin FC-ESC cable, 4 x M3*22 screws, 6 x M3 anti-slip nuts, 12 x 4-to-3mm vibration-reduction silicone, 12 x 4-to-2mm vibration-reduction silicone, 1 x 65mm camera cable, 1 x 25mm camera cable, 1 x receiver cable, 1 x DJI Air Unit cable connector