Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC STABLE 20A TOOTHPICK STACK AIO

Brand
Category: Stack
Kod: MS46891340
(Review Pending)
  • Power Input: 2-4S LiPo
  • Continuous Current (ESC): 20A
  • Mounting (ESC): 26.5x26.5mm (M2)
  • MCU: STM32F411
  • BEC: 5V@1A
  • Burst Current (ESC): 30A

Detail

The GEPRC STABLE 20A TOOTHPICK STACK AIO is a lightweight system for whoop and toothpick drones, made of the GEP-20A-F4 AIO (flight controller and 4in1 ESC on one board) and a 200mW video transmitter. Flight controller: MPU6000 (SPI), MicroUSB, OSD: AT7456E, BEC 5V@1A, input 2-4S LiPo, size 32x32mm, mounting 26.5x26.5mm (M2), firmware target GEPRCF411, supported firmware Betaflight. ESC: MCU BB21F16G, input 2-4S LiPo, ammeter, 20A continuous, 30A burst, DShot600, Oneshot, Multishot, size 32x32mm, mounting 26.5x26.5mm (M2), ESC target/firmware G_H_30 (BLHeli_S). The manufacturer recommends 12XX-15XX motors with 3-4 inch propellers. Note: the manufacturer's spec table names the board "GEP-12A-F4"; the product description says GEP-20A-F4. The included GEP-VTX200-Whoop video transmitter: 5.8GHz, 48 channels (incl. Raceband), PIT/25/100/200mW, input 4.5-5.3V, 300mA, IRC Tramp, U.FL antenna, 2g without antenna. Supported receiver protocols: SBUS, PPM, CRSF, DSMX, iBus.

Box contents

  • 1 x GEP-20A-F4 AIO flight controller, 1 x GEP-VTX200-Whoop video transmitter, 1 x power cable, 8 x screws, 4 x soft silicone
    MCU (FC):
    STM32F411
    IMU(Gyro)(FC):
    MPU6000 (SPI)
    USB Port Type (FC):
    MicroUSB
    Barometer (FC):
    No
    OSD Chip (FC):
    AT7456E
    BLE Bluetooth (FC):
    Not specified by manufacturer
    DJI Air Unit Connection Way (FC):
    Not specified by manufacturer
    6-pin DJI Air Unit Plug (FC):
    Not specified by manufacturer
    Flash(for BlackBox) (FC):
    Not specified by manufacturer
    BetaFlight Camera Control Pad (FC):
    Not specified by manufacturer
    Power Input (FC):
    2-4S LiPo
    5V Output (FC):
    5V@1A
    9V Output (FC):
    Not specified by manufacturer
    3.3V Output (FC):
    Not specified by manufacturer
    4.5V Output (FC):
    Not specified by manufacturer
    ESC Signal Pads (FC):
    Not specified by manufacturer
    UART (FC):
    Not specified by manufacturer
    ESC Telemetry UART (FC):
    Not specified by manufacturer
    LED Pad (FC):
    Yes
    Buzzer (FC):
    Yes (external buzzer)
    BOOT Button (FC):
    Not specified by manufacturer
    Supported Flight Controller Firmware (FC):
    Betaflight
    Firmware Target Name (FC):
    GEPRCF411
    Mounting (FC):
    26.5x26.5mm (M2)
    Dimension (FC):
    32x32mm
    Weight (FC):
    Not specified by manufacturer
    Firmware (ESC):
    FC: GEPRCF411 / ESC: G_H_30 (BLHeli_S)
    PC Configurator Download Link (ESC):
    https://github.com/betaflight/betaflight-configurator/releases
    Continuous Current (ESC):
    20A
    Burst Current (ESC):
    30A
    TVS Protective diode (ESC):
    Not specified by manufacturer
    External Capacitor (ESC):
    Not specified by manufacturer
    ESC Protocol (ESC):
    DShot600, Oneshot, Multishot
    Power Input (ESC):
    2-4S LiPo
    Power Output (ESC):
    Not specified by manufacturer
    Current Sensor (ESC):
    Supported (current meter scale 210)
    ESC Telemetry (ESC):
    No (BLHeli_S ESCs do not support telemetry)
    Mounting (ESC):
    26.5x26.5mm (M2)
    Dimension (ESC):
    32x32mm
    Weight (ESC):
    Not specified by manufacturer