TUR
SpeedyBee F7 Mini
- Power Input: 3S - 6S LiPo
- Mounting: 20 x 20mm, 3.5mm hole diameter
- Dimensions: 30x30x7.5 mm
- Weight: 5.7g
- USB Port Type: Type-C
- MCU (Microcontroller Unit)(Brain): STM32F722
1. Open FC Manual in a New Tab
Click here to open the FC Manual in a new tab2. Download FC Manual
Click here to download the FC ManualMCU:
STM32F722
IMU(Gyro):
BMI270 for current batches; MPU6000 for older batches before May 2022.
USB Port Type:
Type-C
Barometer:
N/A
OSD Chip :
AT7456E chip
BLE Bluetooth :
Supported. Used for Flight Controller configuration (MSP must be enabled on UART 6 at 115200 Baud rate)
DJI Air Unit Connection Way :
Supported
6-pin DJI Air Unit Plug :
Not Specified
Flash(for BlackBox) :
Not Supported. Please download and analyze Blackbox data on your computer
BetaFlight Camera Control Pad :
Yes (CC pad)
Power Input :
3S - 6S LiPo
5V Output :
6 groups of 5V output, five +5V pads and 1 BZ+ pad (used for Buzzer). Total current load is 2.5A.
9V Output :
2 groups of 9V output, total current load is 2A.
3.3V Output :
Supported. Up to 500mA current load.
4.5V Output :
Not Specified
ESC Signal Pads :
M1 - M4
UART :
Full UART * 3 (UART1, UART2, UART3)
ESC Telemetry UART :
R4 (UART4)
LED Pad :
Used for WS2812 LED
Buzzer :
BZ+ and BZ- pads used for 5V Buzzer
BOOT Button :
Used to enter DFU mode
Supported Flight Controller Firmware :
BetaFlight (Default)
Firmware Target Name :
For current batches SPEEDYBEEF7MINIV2 (Gyro: BMI270); for older batches before May 2022 SPEEDYBEEF7MINI (Gyro: MPU6000).
Mounting :
20 x 20mm, 3.5mm hole diameter
Dimension :
30x30x7.5 mm
Weight:
