Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC TAKER F722 8S FLIGHT CONTROLLER

Brand
Category: FC
Kod: MS46891340
(Review Pending)
  • Power Input: 3-8S LiPo
  • MCU: STM32F722
  • Mounting: 30.5x30.5mm (φ4mm hole, φ3mm with silicone dampers)
  • BEC: 5V@3A + 12V@3A
  • Blackbox: 16MB
  • Weight: 8.3g

Detail

The GEPRC TAKER F722 8S FLIGHT CONTROLLER is a GEPRC flight controller. Specs: STM32F722 processor, ICM42688-P (SPI) gyro, 16MB Blackbox, barometer, OSD: AT7456E, Type-C USB, DJI Air Unit plug-and-play connector, BEC 5V@3A + 12V@3A, 6 UARTs, 8 motor outputs (M1-M8), input 3-8S LiPo, size 38.5x38.5mm, mounting 30.5x30.5mm (φ4mm hole, φ3mm with silicone dampers), weight 8.3g, firmware target GEPRC_TAKER_F722_8S, supported firmware Betaflight. Note: the manufacturer lists the weight as 8.3g on the FC page and 8.1g on the stack pages.

Box contents

  • 1 x TAKER F722 8S flight controller, 1 x DJI connection cable (SH1.0 6pin 100mm), 2 x FC adapter cable (SH1.0 8pin 30mm), 4 x nylon nuts, 4 x silicone grommets, 2 x receiver cable (SH1.0 4pin 150mm), 1 x camera cable (SH1.0-SH1.25 3pin 60mm)
1. Open FC Manual in a New Tab
Click here to open the FC Manual in a new tab
2. Download FC Manual
Click here to download the FC Manual
FC: GEPRC TAKER F722 8S FLIGHT CONTROLLER Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU:
    STM32F722
    IMU(Gyro):
    ICM42688-P (SPI)
    USB Port Type:
    Type-C
    Barometer:
    Supported
    OSD Chip :
    AT7456E
    BLE Bluetooth :
    No
    DJI Air Unit Connection Way :
    DJI Air Unit plug-and-play connector
    6-pin DJI Air Unit Plug :
    Supported
    Flash(for BlackBox) :
    16MB
    BetaFlight Camera Control Pad :
    Not specified by manufacturer
    Power Input :
    3-8S LiPo
    5V Output :
    5V@3A
    9V Output :
    12V@3A
    3.3V Output :
    Not specified by manufacturer
    4.5V Output :
    Not specified by manufacturer
    ESC Signal Pads :
    8 motor outputs (M1-M8)
    UART :
    6 UARTs
    ESC Telemetry UART :
    Not specified by manufacturer
    LED Pad :
    Not specified by manufacturer
    Buzzer :
    Not specified by manufacturer
    BOOT Button :
    Not specified by manufacturer
    Supported Flight Controller Firmware :
    Betaflight
    Firmware Target Name :
    GEPRC_TAKER_F722_8S
    Mounting :
    30.5x30.5mm (φ4mm hole, φ3mm with silicone dampers)
    Dimension :
    38.5x38.5mm
    Weight:
    8.3g