HGLRC SPECTER F722 Lite ELRS 2.4G FC

Brand
Kod: MS46891340

  • Power Input: 2S - 6S LiPo (8.4-25.2V)
  • Mounting: 20x20mm (M3)
  • Dimensions: 28x28mm
  • Weight: 4g
  • Built-in Receiver: ELRS 2.4GHz
  • MCU (Microcontroller Unit): STM32F722

Detail

The HGLRC SPECTER F722 Lite is an ultra-light 4g, 20x20mm flight controller with a built-in ELRS 2.4G receiver; an external receiver can also be used (it uses the same serial port as the built-in receiver). The F722 processor offers double-precision floating-point acceleration; according to HGLRC it responds 40% faster than the F4 series and supports high-frequency PID refresh, suitable for aggressive freestyle and high-speed racing. It features an ICM42688P gyro, DPS310 barometer, AT7456E OSD and a 16MB black box. With a wide 2S-6S voltage range it is compatible with everything from light 3-inch cinematic drones to 7-inch long-range drones; its 5V 2A BEC removes the need for an external BEC. The VTX output can be selected as 5V or battery voltage (BAT) with a solder bridge, compatible with most analog and HD video transmission systems. It has FC BOOT and ELRS BOOT buttons. Package contents: FC, 25mm 8-pin FC cable, 90mm and 40mm 2.4G T-type antennas, 4x M3x8 shock absorbers.

Box contents

1. Open FC Manual in a New Tab
Click here to open the FC Manual in a new tab
2. Download FC Manual
Click here to download the FC Manual
FC: HGLRC SPECTER F722 Lite ELRS 2.4G FC Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU:
    STM32F722
    IMU(Gyro):
    ICM42688P
    USB Port Type:
    Type-C
    Barometer:
    DPS310
    OSD Chip :
    AT7456E
    BLE Bluetooth :
    Not specified
    DJI Air Unit Connection Way :
    Solder pads (BAT, GND, RX3, TX3, GND, SBUS)
    6-pin DJI Air Unit Plug :
    Not specified
    Flash(for BlackBox) :
    16MB
    BetaFlight Camera Control Pad :
    Not specified
    Power Input :
    2S-6S LiPo (8.4-25.2V; 8.4-26.1V on the spec sheet image)
    5V Output :
    5V 2A
    9V Output :
    None (VTX pad 5V or BAT via solder bridge)
    3.3V Output :
    Not specified
    4.5V Output :
    Not specified
    ESC Signal Pads :
    1x 4in1 ESC connector (8-pin, M1-M4)
    UART :
    5 UARTs
    ESC Telemetry UART :
    UART6 (RX6)
    LED Pad :
    Yes (LED)
    Buzzer :
    Yes (BB-)
    BOOT Button :
    Yes (FC BOOT and ELRS BOOT)
    Supported Flight Controller Firmware :
    Betaflight
    Firmware Target Name :
    HGLRCF722MINI (4.5.1)
    Mounting :
    20x20mm, M3
    Dimension :
    28x28mm
    Weight:
    4g