TUR
SpeedyBee F7 V2 Flight Controller
- Power Input: 3S - 6S Lipo
- Mounting: 30.5 x 30.5 mm, 4 mm hole size
- Dimensions: 41x38x6.9 mm
- Weight: 9 g
- USB Port Type: Type-C
- MCU (Microcontroller Unit)(Brain): STM32F722
MCU:
STM32F722
IMU(Gyro):
MPU6000
USB Port Type:
Type-C
Barometer:
BMP280(I2C) Warning: Do not apply conformal coating on the barometer as the air hole may become blocked.
OSD Chip :
BetaFlight OSD w/ AT7456E chip
BLE Bluetooth :
Supported, used for flight controller configuration
DJI Air Unit Connection Way :
There is a complete DJI Air Unit JST slot onboard
6-pin DJI Air Unit Plug :
Not specified
Flash(for BlackBox) :
16MB built-in data flash
BetaFlight Camera Control Pad :
Yes
Power Input :
3S - 6S Lipo
5V Output :
5V output x 7 units, 6 pads and a BZ+ pad used for the buzzer with a total maximum load current of 2.5A.
9V Output :
2 x 9V output, with 1 pad and 1 pad used for 1 DJI slot, totaling a maximum load current of 2.5A.
3.3V Output :
1 * 3.3V output pad, maximum load current of 500mA.
4.5V Output :
1 * 4.5V output pad
ESC Signal Pads :
M1 - M4
UART :
Full UART * 5 (UART1, UART2, UART3, UART5, UART6)
ESC Telemetry UART :
UART4 RX
LED Pad :
Used for WS2812 LED
Buzzer :
BZ+ and BZ- pads used for 5V Buzzer
BOOT Button :
Used to easily enter DFU mode
Supported Flight Controller Firmware :
BetaFlight (Default), EMUFlight
Firmware Target Name :
SPEEDYBEEF7V2
Mounting :
30.5 x 30.5 mm, 4 mm hole size
Dimension :
41x38x6.9 mm
Weight:
