Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb

GEPRC GEP-F722 HD FLIGHT CONTROLLER

Brand
Category: FC
Kod: MS46891340
(Review Pending)
  • Power Input: 3-6S LiPo
  • MCU: STM32F722RET6
  • Mounting: φ4mm hole, φ3mm with grommets (hole spacing not specified)
  • BEC: 5V + 9V
  • Blackbox: 16Mb
  • Weight: Not specified by manufacturer

Detail

The GEPRC GEP-F722 HD FLIGHT CONTROLLER is a GEPRC flight controller. Specs: STM32F722RET6 processor, MPU6000 (SPI) gyro, 16Mb Blackbox, barometer, OSD: AT7456E, Type-C USB, Direct plug-in for the DJI Digital FPV System, BEC 5V + 9V, 4 UARTs (per FC page), input 3-6S LiPo, size 36x36mm, mounting φ4mm hole, φ3mm with grommets (hole spacing not specified), firmware target GEPRCF722, supported firmware Betaflight. BEC outputs are listed as 5V and 9V without current ratings. Note: the manufacturer lists 4 UARTs on the FC page and 5 UARTs on the SPAN F722 HD stack page. Supported receivers: Frsky XM/XM+/R-XSR, Futaba, DSM/DSMX, FlySky, TBS Crossfire, AC900 and most SBUS receivers.

Box contents

  • 1 x GEP-F722-HD flight controller, 4 x M4-to-M3 silicone grommets, 1 x ESC cable, 1 x DJI cable
1. Open FC Manual in a New Tab
Click here to open the FC Manual in a new tab
2. Download FC Manual
Click here to download the FC Manual
FC: GEPRC GEP-F722 HD FLIGHT CONTROLLER Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU:
    STM32F722RET6
    IMU(Gyro):
    MPU6000 (SPI)
    USB Port Type:
    Type-C
    Barometer:
    Supported (BMP280)
    OSD Chip :
    AT7456E
    BLE Bluetooth :
    Not specified by manufacturer
    DJI Air Unit Connection Way :
    Direct plug-in for the DJI Digital FPV System
    6-pin DJI Air Unit Plug :
    Supported
    Flash(for BlackBox) :
    16Mb
    BetaFlight Camera Control Pad :
    Not specified by manufacturer
    Power Input :
    3-6S LiPo
    5V Output :
    5V
    9V Output :
    9V
    3.3V Output :
    Not specified by manufacturer
    4.5V Output :
    Not specified by manufacturer
    ESC Signal Pads :
    Not specified by manufacturer
    UART :
    4 UARTs (per FC page)
    ESC Telemetry UART :
    Not specified by manufacturer
    LED Pad :
    Not specified by manufacturer
    Buzzer :
    Not specified by manufacturer
    BOOT Button :
    Not specified by manufacturer
    Supported Flight Controller Firmware :
    Betaflight
    Firmware Target Name :
    GEPRCF722
    Mounting :
    φ4mm hole, φ3mm with grommets (hole spacing not specified)
    Dimension :
    36x36mm
    Weight:
    Not specified by manufacturer