Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC TAKER H743 MINI 32Bit 60A STACK

Brand
Category: Stack
Kod: MS46891340
(Review Pending)
  • Power Input: 3-8S LiPo
  • Continuous Current (ESC): 60A
  • Mounting (FC and ESC): 20x20mm
  • MCU: STM32H743
  • BEC: 5V@3A + 12V@2.5A
  • Burst Current (ESC): 65A (5 seconds)

Detail

The GEPRC TAKER H743 MINI 32Bit 60A STACK is GEPRC's next-generation mini flight stack: a TAKER H743 MINI flight controller with an STM32H743 (Cortex-M7) MCU and ICM42688-P gyro, paired with the TAKER H60 MINI 60A 4in1 ESC with AM32 pre-installed. Flight controller: 16MB Blackbox, Bluetooth wireless tuning, built-in barometer, external gyro clock input support, 8 motor outputs (X8 support), dual independent BEC (5V@3A + 12V@2.5A), TVS spike protection, integrated LC filter, Type-C USB, DJI plug-and-play connector, 7 UARTs (UART8 reserved for Bluetooth), input 3-8S LiPo, size 31x31mm, mounting 20x20mm, weight 6.1g, firmware target GEPRC_TAKER_H743MINI. ESC: TAKER H60 MINI AM32 60A, input 3-8S LiPo, 60A continuous, 65A burst (5 s), DShot150/300/600, size 43x36mm, mounting 20x20mm, weight 17g (with aluminium heat sink), firmware AM32 GEPRC 4IN1 F421.

Box contents

  • 1 x TAKER H743 MINI flight controller, 1 x TAKER H60 MINI 32bit ESC, 1 x 50V 1000µF capacitor, DJI Air Unit cable (SH1.0-6P), FC cable (SH1.0-8P), FC to GPS/RX cable (SH1.0-4P), XT60 power cable (12AWG, 55mm), 10 x M3 silicone dampers, 5 x M3*22 stack screws, 6 x M3 nylon lock nuts, 5 x M3 hex nuts
1. Open STACK Manual in a New Tab
Click here to open the STACK Manual in a new tab
2. Download STACK Manual
Click here to download the STACK Manual
STACK: GEPRC TAKER H743 MINI 32Bit 60A STACK Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU (FC):
    STM32H743
    IMU(Gyro)(FC):
    ICM42688-P
    USB Port Type (FC):
    Type-C
    Barometer (FC):
    Supported
    OSD Chip (FC):
    AT7456E
    BLE Bluetooth (FC):
    Supported (UART8)
    DJI Air Unit Connection Way (FC):
    DJI Air Unit plug-and-play connector
    6-pin DJI Air Unit Plug (FC):
    Supported
    Flash(for BlackBox) (FC):
    16MB
    BetaFlight Camera Control Pad (FC):
    Not specified by manufacturer
    Power Input (FC):
    3-8S LiPo
    5V Output (FC):
    5V@3A
    9V Output (FC):
    12V@2.5A
    3.3V Output (FC):
    Not specified by manufacturer
    4.5V Output (FC):
    Not specified by manufacturer
    ESC Signal Pads (FC):
    8 motor outputs (M1-M8)
    UART (FC):
    7 UARTs (UART8 reserved for Bluetooth)
    ESC Telemetry UART (FC):
    Not specified by manufacturer
    LED Pad (FC):
    Not specified by manufacturer
    Buzzer (FC):
    Not specified by manufacturer
    BOOT Button (FC):
    BOOT pad
    Supported Flight Controller Firmware (FC):
    Betaflight
    Firmware Target Name (FC):
    GEPRC_TAKER_H743MINI
    Mounting (FC):
    20x20mm
    Dimension (FC):
    31x31mm
    Weight (FC):
    6.1g
    Firmware (ESC):
    FC: GEPRC_TAKER_H743MINI / ESC: AM32 GEPRC_4IN1_F421
    PC Configurator Download Link (ESC):
    https://github.com/betaflight/betaflight-configurator/releases
    Continuous Current (ESC):
    60A
    Burst Current (ESC):
    65A (5 seconds)
    TVS Protective diode (ESC):
    Yes
    External Capacitor (ESC):
    50V 1000µF capacitor included
    ESC Protocol (ESC):
    DShot150/300/600
    Power Input (ESC):
    3-8S LiPo
    Power Output (ESC):
    Not specified by manufacturer
    Current Sensor (ESC):
    Not specified by manufacturer
    ESC Telemetry (ESC):
    Not specified by manufacturer
    Mounting (ESC):
    20x20mm
    Dimension (ESC):
    43x36mm
    Weight (ESC):
    17g (with aluminium heat sink)