Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Electronics Black Wrist Watch
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb
Product Thumb

GEPRC TAKER F722 SE FLIGHT CONTROLLER

Brand
Category: FC
Kod: MS46891340
(Review Pending)
  • Power Input: 2-6S LiPo (7.4-25.2V)
  • MCU: STM32F722RET6
  • Mounting: 25.5x25.5mm (φ4mm hole, converts to 3mm or 2mm screws with silicone)
  • BEC: 5V@2.5A + 10V@2A
  • Blackbox: 32Mb
  • Weight: 6.0g

Detail

The GEPRC TAKER F722 SE FLIGHT CONTROLLER is a GEPRC flight controller. Specs: STM32F722RET6 processor, MPU6000 (per FC page) gyro, 32Mb Blackbox, OSD: AT7456E, Type-C USB, Direct plug-in for DJI Air Unit (per the GEPRC stack page), BEC 5V@2.5A + 10V@2A, 6 UARTs (UART6 for ESC only), input 2-6S LiPo (7.4-25.2V), size 31.7x31.5mm, mounting 25.5x25.5mm (φ4mm hole, converts to 3mm or 2mm screws with silicone), weight 6.0g, firmware target TAKERF722SE, supported firmware Betaflight. Note: the manufacturer lists the gyro as MPU6000 on the FC page and ICM42688-P on the E55A SE stack page.

Box contents

  • Not specified by manufacturer
1. Open FC Manual in a New Tab
Click here to open the FC Manual in a new tab
2. Download FC Manual
Click here to download the FC Manual
FC: GEPRC TAKER F722 SE FLIGHT CONTROLLER Manual Connection Image
Open the Manual in a New Tab Manual Connection Image
    MCU:
    STM32F722RET6
    IMU(Gyro):
    MPU6000 (per FC page)
    USB Port Type:
    Type-C
    Barometer:
    Not specified by manufacturer
    OSD Chip :
    AT7456E
    BLE Bluetooth :
    Not specified by manufacturer
    DJI Air Unit Connection Way :
    Direct plug-in for DJI Air Unit (per the GEPRC stack page)
    6-pin DJI Air Unit Plug :
    Supported
    Flash(for BlackBox) :
    32Mb
    BetaFlight Camera Control Pad :
    Not specified by manufacturer
    Power Input :
    2-6S LiPo (7.4-25.2V)
    5V Output :
    5V@2.5A
    9V Output :
    10V@2A
    3.3V Output :
    Not specified by manufacturer
    4.5V Output :
    Not specified by manufacturer
    ESC Signal Pads :
    Not specified by manufacturer
    UART :
    6 UARTs (UART6 for ESC only)
    ESC Telemetry UART :
    Not specified by manufacturer
    LED Pad :
    Not specified by manufacturer
    Buzzer :
    Not specified by manufacturer
    BOOT Button :
    Not specified by manufacturer
    Supported Flight Controller Firmware :
    Betaflight
    Firmware Target Name :
    TAKERF722SE
    Mounting :
    25.5x25.5mm (φ4mm hole, converts to 3mm or 2mm screws with silicone)
    Dimension :
    31.7x31.5mm
    Weight:
    6.0g