TUR
FETtec 4in1 ESC 65A
- Continuous Current: 65A x4
- Burst Current: Not Specified
- Power Input: 3-8S LiPo
- Mounting: 30.5x30.5mm (M3, expandable to M4)
- Dimensions: 38*48mm
- Weight: 13.6g
Detail
The FETtec 4in1 ESC 65A is a 4-in-1 ESC based on the STM32G071 (64MHz), built with high-quality 40V MOSFETs and featuring active current limiting. It supports a 3S-8S LiPo input voltage. It comes with FETtec proprietary firmware, with KISS and Betaflight passthrough support. An integrated current and voltage sensor provides serial telemetry through the TLM pad. The mounting holes are 30.5x30.5mm M3 and can be carefully expanded to M4 (filing the holes may cause damage). For 4-6S operation, connecting the included capacitor (min. 470μF, 50V, ESR<1ohm) is recommended; for 8S operation, this capacitor and an additional BEC on the FC are mandatory.
Box contents
1. Open ESC Manual in a New Tab
Click here to open the ESC Manual in a new tab2. Download ESC Manual
Click here to download the ESC ManualFirmware:
FETtec Firmware (proprietary firmware; supports KISS FC Passthrough and Betaflight Passthrough)
PC Configurator Download Link :
https://gui.fettec.net/ESC/index.html
Continuous Current :
65A (with active current limiting)
Burst Current :
Not Specified
TVS Protective diode :
Not Specified (no integrated TVS diode; manufacturer recommends the separate "FETtec Spike-Absorber" accessory)
External Capacitor :
Required, included in the package (minimum 470μF, 50V, ESR<1ohm; mandatory for 8S operation)
ESC Protocol :
DShot300-2400, PWM, Oneshot42/125, Onewire, S2M (automatic signal detection)
Power Input :
3-8S LiPo
Power Output :
Not Specified (no integrated BEC; an additional BEC through the FC is required for 8S operation)
Current Sensor :
Yes (integrated current and voltage sensor, compatible with Betaflight ESC_SENSOR)
ESC Telemetry :
Yes (half-duplex serial telemetry through the TLM pad)
Mounting :
30.5 x 30.5 mm (M3, can be carefully expanded to M4)
Dimension :
38 x 48 mm (maximum external dimensions)
Weight :
